Note that due to a bug in the elog the name appeared wrongly in my previous message. In general: Avoid underscores in the file names! 

In addition it should be tried to have a so called "Happy Hour" every day from 0800 - 1000. During this time loops should be up if possible. Meaning that in the evening before leaving, developers bring loops back up.

Tomorrow, 14th of March, Vacuum and Motion loop will be down at least during morning due to technical reasons .

I will notify you when the works are finished.

Dear all,

Finally today the Vacuum and Motion will still running the hole day and I would have to stop them tomorrow morning. Before doing this operation, I will post an entry in the ELOG.

Today Denis has to make some changes in the Vacuum and Motion hardware loop, therefore they would be down some time.

At least, we would try to keep the Vacuum loop up again for 3pm, therefore Valerii and Raul could use it with Karaboo.

Vacumm and Motion are running again after the hardware changes.

Wiring status SASE 1:

Wiring progress:

• Internal wiring of the XGM in XTD 9 is done.
• Vacuum part wiring of the XGM in XTD 9 is done (ready for local Beckhoff test).
• Gas Panel wiring of the XGM in XTD 9 is done.
• Crate wiring (ADAM & Femto crate) of the XGM in XTD 9 is done.

Upcoming work XTD 2:

• Serial connection from Beckhoff to TCP 350.
• Change cold plug cables into halogenfree cables.

Upcoming work XTD 9:

• INHIBIT connection Iseg HV crate.
• Serial connection from MTCA to RVC 300.

Upcoming work XTD 10:

• Vacuum part wiring of XGM.
• Gas Panel wiring of XGM.
• Internal wiring of XGM.
• Installing ADAM & Femto crate.
• Measure cable lengths for Imager and prepare cables.

Dear all,

Tomorrow in the morning is needed to add some fuses in the PLCs crate, therefore Vacuum and Motion would be down for more or less one hour from 9am. I will notify you when the PLCs are available to work again.

Thank you,

Dear all, Vacuum and Motion loops are running again.

Thank you,

Dear all,

find here the foreseen loop status for KW12. The schedule could change. All changes will be notified by entries in the logbook.

FYI. The Motion loop is again up and running.

Dear all,

tomorrow morning at 10h am, we will need the Motion PLC for roughly half hour to do some tests. During this time the PLC will be stop.

Dear all,

The Motion loop is up and running again.

Thank you!

Dear all,

EPS loop is running with the latest hardware updates. Today, when I was trying to update the loop, I have found that someone has powered off the EPS crate in XTD2 Rack 1.5. Please, if you have to do some work in any part of SASE 1, let us know about it.

Thank you!