Dear all,

The motion loop will be updated in 5 minutes. The IMGs are already in safe state, please do not operate nothing. I have already contacted the control room and Harald Sinn as representative of the commissioning team.

Thank you!

The Motion loop is again up and running.

Thank you

Dear all,

The OCD AE numbers for the following days will be:

PLC support: 9-8040

DAQ Electronics (incl. timing, MicroTCA) Support:  9-8041

If there are any change in the numbers, we will let you know.

Thank you.

Dear all,

I have already contacted Andreas Koch, and Alessandro has contacted the BKR in order to do a new update of the motion loop because of one small bug detected.

I will do the update in the next few minutes.

Thank you,

Dear all,

It is needed to add two digital input terminals in Rack 1.17 and 1.18 in XTD9 for the vacuum loop, and Denis will do it in the next minutes. Therefore you will loose communication for those motion racks.

Thank you

Dear all,

Sorry, my last message was not correct. We will do the hardware changes when we have prepared the Vacuum update also.

Thank you

Dear all,

We will run the update of the Vacuum loop in the next half hour.

Thank you!

Dear all,

I will make an update of the Motion loop in the next minutes, all the systems are in safe state.

Thank you

We will run again an update in the Vacuum loop, just to fix small bug detected.

Thank you

Dear all, we will run another update in the Motion loop.

Thank you

Dear all,

We have detected with Karabo guys that there was a problem in the IonPumps in SASE1. The IonPumps are working, Raúl went to the Tunnel to check the controllers in XTD9 to confirm that.

According with Raúl and CAS people, we have arranged to do the next Vacuum update tomorrow early in the morning. I will post a new entry to let you know and I will contact now WP74 people in order to be quickly with the loop update tomorrow.

Thank you and sorry for the disturbing.

Dear all, we will proceed with the update of the Vacuum loop.

Thank you!

Dear all,

We will start with the Motion loop update. Will take us a little bit, around 3 hours, but I will let you know when it has finished.

Thank you,

Dear all,

The Motion loop is running again. We have included today the Mc2motor devices that were already before configured (FXE PBLMs and MCP), tomorrow we will include the rest of the PBLMs.

Right now is also into the loop the Hirex hardware in Rack 1.8 and the new crate of the Rack 1.18 for the temperature measurements.

Thank you,

Dear all,

Due to some hardware changes needed in Motion loop, we will last a little bit more in the Motion update. You will loose communication but I will come back when it is running again.

Thank you and sorry for inconvenience.

Dear all,

Motion loop is up and running again, now with all the PBLMs configured.

Thank you,

Dear all,

We will be working in the Motion loop till this afternoon. So as I said in the morning meeting, I will let you know when we have finished.

Thank you

Dear all,

Today we are planning to integrate part of Hirex motors into the Motion loop of SASE1. Therefore, the loop will be break, so you will loose communication with whole XTD9 Motion part. I will back again to you when we are done,

Thank you

Dear all,

I have received a request from Konstantin Sukharnikov to break the Motion loop in XTD2 from Rack 1.5 in order to do checks in the CRLs. So you will loose communication with almost the whole Motion loop in SASE1. I will let you know when they are finished.

Thank you,

We are finished. One encoder terminal has failed and needs replacing: rack 1.5 EC14