General Announcement:
-	 

CTRL:
- Issue with mc2 motor (pop-up issue for step-up command): it has been identified and fixed. New version will be deployed in the shutdown. Workaround until then is to stop and restart device.

DA:
- On the slow migration/calibration at MID: it is understood as overload of cluster nodes responsible for migration; mitigated by adding two more nodes. Calibration services shall run better from now. 

EEE:
- Drifts with SQS digitizers: yesterday Bruno F. was working on it and it shall be fixed now.

VAC:
- Nothing to report.

XPD:
- Nothing to report.

DET:
- Nothing to report.

ITDM: 
- Nothing else to add apart of DA report - still more investigation is ongoing.

XRO:
- Nothing to report.

LAS:
- All fine with lasers.

UNSYS:
- In SA3: two encoders that were exchanged (cell#17 and cell#20) on Monday's ZZ. 
- Another PS (SA3/cell21) stopped working. Motor has to be replaced in a next ZZ (request placed). 
Suren K. also says that the whole intersection is not working (not able to recover after restart the system - Quad stays in position for operation). 
- SA1/cell14 a coupler of the undulator terminal was replaced.

SPB:
- AGIPD issue also observed last week and is under investigation. DET is aware and under investigation.

FXE:
- Nothing to report.

MID:
- Issue with calibration: MID would like to test it in order to close the review.

HED:
- Running user experiment this week.

SCS:
- Nothing to report.

SQS:
- Nothing to report.